Reset both HDs to non-member using Intel BIOS utility - the utility warns that all data will be lost - in fact only metadata is lost and can be recreated using steps below.Ģ. I was able to recover the broken array using following steps.ġ. I found a solution and I thought I'd share it. Meh looks like I'm going to have to delete my RAID 0 volume, all because of a CMOS battery lol ah well :/ Should I just delete the RAID0 Volume that has shown up as Failed in the list and recreate it? Will I lose all my data on the SSD's by doing this? The one found as the RAID disk is not in the list: The Recovery Volume options and acceleration options (4 and 5) will not let me select them otherwise I would have looked into the recovery options.ĮDIT: Click the image to enlarge it and yes the Crucial drives are the SSD'sĮDIT: Also when I try to create a new RAID volume, only the "Non RAID Volume" SSD shows up and I need to select 2 disks. I have enabled Raid0 but where it says all my storage drives, the 2 SSD's used in the Raid setup, one of them says "Failed" and that it is a "Non-Raid Disk" so do I just select option one from the screen shot which says "Create RAID Volume" (its hard to read from the screen shot) or will this reformat it? I want to be extra sure just in case. Okay, so I finally replaced the battery of the motherboard and now I am trying to configure my Raid0 setup so that I do not lose my data. That said, if the battery was already dead, and the machine had not been powered on for "a while" (again, very difficult to give any form of time frame here) these settings would have already been lost before the battery swap.Īre you sure that the batter(ies) went back in the right way round/up? ![]() should normally be enough residual charge in the motherboards capacitors for a battery swap if you do it "quickly" (of course how much residual charge depends on so many other factors it's practically impossible to give an accurate time frame) but as a general rule, as long as you do the swap within 15-20 seconds you should be ok without having issues with any settings being lost. ![]() Here's a thread about someone having a similar issue with their Raid 0 setup. You should reflash and reconfigure the BIOS on your mobo. Without the power from that battery there's nothing to maintain the electrical charge of the CMOS data on the mobo. (I did look online every where but it seems I'm the only one with this issue.) Should I try restarting my PC again or is there something more simple I could try so I don't have to lose everything again? I was wondering if there is a program that might have been disabled on start up in "msconfig" or something but no clue. It is set to update using the internet time "" and I have changed this around to test all other possible options and it makes no difference. When it gets close to the next hour like "15:59" for example, instead of switching to "16:00" it changes to "15:00" which makes no sense.Īll my time settings for the clock have never been changed and are not incorrect what so ever. When I restart my PC and log in, the time will not update to the current time and instead it shows the time during the last time it was on. ![]() It does not do this on my laptop, just my desktop PC is it is very frustrating. Hi, I've been having a bug with my clock not changing to the correct time and the strangest part is that I completely restored my PC back to factory settings and it still is happening!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |